Brother MFC-6800 - Manual (Page 64)

6 - 5 S E T U P S E N D
3
Press Fax Start. The MFC starts scanning the original and the LCD shows the
job number (#XX) of the fax and how much memory is available. Then the
machine starts dialing. For the next fax, you can repeat steps 1 through 4
immediately.
Real Time Transmission
When you are sending a fax, the MFC will scan originals into memory before sending.
Then, as soon as the phone line is free, the MFC will start dialing and sending the fax.
If memory becomes full, the MFC will send the document in real time (even if
REAL
TIME TX is set to OFF ).
Sometimes you may want to send an important document immediately, without
waiting for memory transmission. You can set
REAL TIME TX to ON .
1
Place the original face up in the ADF, or face down on the scanner glass.
2
Press Menu/Set, 2, 2, 6.
3
To change the default setting, press to
select ON (or OFF ), and then press
Menu/Set.
Go to Step 5—OR—For the next fax transmission only, press to select
NEXT FAX ONLY , and then press Menu/Set.
4
For the next fax only, press to select ON (or OFF ), and then press
Menu/Set.
Note
Your MFC normally operates in Dual Access mode.
The number of pages you can scan into memory varies with the data they
contain.
6.REAL TIME TX
or
or
or