Brother MFC-6800 - Manual (Page 84)

9 - 4 R E M O T E F A X O P T I O N S
Remote Commands
Follow the commands below to access features remotely. When you call the
MFC and enter your Remote Retrieval Access Code (1 5 9 ), the system will
signal you with two short beeps to enter a remote command.
Remote Commands Operation Details
95 Changing Fax
Forwarding
/Paging setting
1 OFF If you hear one long beep, the change is
accepted. If you hear three short beeps, you
cannot change it because the conditions have
not been met (Example: registering paging
number). You can register your fax forwarding
number by using 4. FAX FWD NO. (see page
9-5). Once you have registered the number, the
MFC will change automatically to
FAXFWD:ON mode.
2 Fax Forwarding
3 Paging
4 FAX FWD No.
6 Fax Storage ON You can turn FAX STORAGE to ON or OFF.
7 Fax Storage OFF
96 Retrieve a fax
2 Retrieve all faxes Enter the number of a remote fax machine to
receive stored fax messages. (See page 9-5.)
3 Erase faxes from the
memory If you hear one long beep, you can erase fax
message(s) from the memory.
97 Check the Receiving
Status
1 FAX You can check whether your MFC has received
any faxes. If yes, you will hear one long beep.
If no, you will hear three short beeps.
98 Change the Receive
Mode
1 EXT.TEL/TAD If you hear one long beep, you can change the
Receive Mode.
If you hear three short beeps, you cannot
change it.
3 FAX ONLY
90 Exit After a long beep, you can exit Remote
Retrieval.