Canon TX-20 Full Auto Tonometer - Manual (Page 76)

76
6Maintenance
6
Cut the paper.
Paper that is automatically cut has 1.5 mm of uncut paper in the middle of the cut so it does not fall
off. Hold the tip of the paper and slowly pull it to cut it.
Always remove the automatically cut paper.
Printing again while the cut paper is still attached may cause paper jams.
Preparations for Packing and Transport
Before packing and transporting the TX-20, move its measurement unit and chin rest to the optimal
position for packing and moving.
The measurement unit moves to the central lowest position. The chin rest moves all the way down.
1
While pressing the R/L button, turn on the power.
Continue pressing the R/L button after turning on the power until the buzzer sounds.
The chin rest and the measurement unit automatically move to the packing and transport position.
The following message appears on the monitor.
Transportation Package Position.
Please power down and remove the printing paper.
After that, the TX-20 cannot be operated. To do measurements again, the power must be turned off
and on again.
2
Turn off the power.
Remove the paper from the printer after turning off the power. Unplug the power cord from the
electric outlet and remove the cables to any connected devices.
L-IE-5191C_TX-20.indb 76 2013/07/18 13:10:40