Clearing jammed roll paper – Canon imagePROGRAF iPF6450 User Manual
Page 977
5
Fold an A4 sheet lengthwise four times and insert it through
the gap of the Back Cover. Push the scrap out toward the
Platen.
6
Remove the scrap when it is pushed out onto the Platen.
7
If any scraps remain inside the paper feed slot, repeat steps 5 and 6.
8
Close the Top Cover.
9
Turn the printer off. (See "Turning the Printer On and Off.")
Clearing Jammed Roll Paper
Clearing Jammed Roll Paper
If paper from a roll becomes jammed, "Paper jam" is shown on the Display Screen of the Control Panel. Remove the
jammed paper as follows.
Important
•
For instructions on removing scraps from the paper feed slot after clearing jammed roll paper, see "Clearing Jammed Paper
(Paper Feed Slot)."
1
Open the Roll Feed Unit Cover. Use commercially availa-
ble scissors or the like to cut the paper of the loaded roll.
Caution
•
When cutting paper, be careful to avoid injury or damage to the printer.
Note
•
If it is difficult to perform operations from the front of the printer, perform operations from the back of the printer.
If the printer has a Spectrophotometer Unit (option), lowering the Up-down Unit makes it easier to perform operations
from the front of the printer. (See "Lowering the Up-down Unit of the Spectrophotometer Unit (option) Manually.")
iPF6450
Clearing Jammed Roll Paper
Troubleshooting
Problems Regarding Paper
977