HP XP External Storage Software - Manual (Page 80)

Preset list (LU Operation pane)
Displays rows from the Device list that are about to be acted upon. You can apply settings to the local
array after checking the contents in the Preset list. Information displayed in the Preset list appears in
blue italics in the Device list. If you click Apply in the LU Operation pane, settings displayed in the
Preset list are applied to the local array. At that point, the contents of the Preset list disappear and
the Device list appears normally.
If you click Cancel in the LU Operation pane, all settings in the Preset list are canceled.
If settings in the Preset list contain errors, they are not applied to the local array even if you click
Apply. In that case, error messages appear and incorrect settings appear in the Preset list. In addition,
error codes appear in the Preset list.
NOTE:
Depending on the type of errors that occur, identical error codes might be displayed for all errors listed
in the
Preset list. In this case, check the status of settings to identify the source of the error.
When you right-click an item in the Preset list, the following commands appear:
• Detail
Displays the Preset Detail window with detailed information about settings selected in the Preset
list. When an error code appears in the Preset list, a corresponding error message appears in
this window.
Figure 36 Preset Detail window (mapping operation)
• Delete
Cancels settings selected in the Preset list.
Port Operation pane
Use this pane to check port settings and set port attributes. This section describes items displayed in
the Port Operation pane. For instructions, see
Setting a local array's port attributes .
External Storage XP panes 80