Viewing xp continuous access pair status – HP StorageWorks XP Remote Web Console Software User Manual
Page 127
1.
Connect to the MCU of the pair(s) for which you want to change the pair option, and open
the XP Continuous Access main window.
2.
In the tree, select a port, host group, desired CU, or upper CU grouping.
3.
In the list, select the pair(s) for which you want to change the pair option. When a port is
selected in the tree, the pair(s) can be selected from the current volume list.
Select either XP Continuous Access Synchronous pairs or XP Continuous Access Asynchronous
pairs (not both). Use the Display Filter as needed to display the desired pairs (for example,
select Async only)
4.
Right-click, and click Change Pair Option to open the Change Pair Option dialog box (see
“Change Pair Option Dialog Box (Synchronous and Asynchronous)” (page 126)
).
5.
On the Change Pair Option dialog box, select the desired pair option for the selected pair(s),
and click Set to close the Change Pair Option dialog box. The preview list displays the
requested change pair option operation(s).
6.
Verify the requested operation(s) in the preview list.
To change one or more operations, select the operation(s) from the preview list, right-click,
and click Modify. To remove one or more operations, select the operation(s), right-click, and
click Delete. To cancel all operations, select all the operations in the preview list, right-click,
and click the Delete command, or click the Cancel button.
7.
To perform the change pair option, click the Apply button.
If one or more operation(s) did not start normally, the preview list displays only the operation(s)
that did not start normally. An error code is displayed in the Error Code column in the preview
list. To display an error message, select one LU, right-click, and click Error Detail. After you
see an error message, click OK to close the error message.
8.
On the Pair Operation window, verify that the change pair option operation(s) completed
successfully.
If an error occurs, you can display the error message by right-clicking on the operation and
clicking the Error Detail command.
Viewing XP Continuous Access Pair Status
The Detailed Information dialog box (see
) displays the detailed pair status
information for the selected pair. To open the Detailed Information dialog box, click the Pair
Operation tab, select a CU grouping, CU, port, or host group from the tree, select the desired pair,
right-click, and then click the Detailed Information command.
Viewing XP Continuous Access Pair Status
127