Adding and deleting ssids for an rcu – HP StorageWorks XP Remote Web Console Software User Manual
Page 92
6.
Verify the requested operation(s) displayed in the preview list.
7.
To change the add path operation, select the operation from the preview list, right-click, and
click Modify. To remove the operation, select the operation, right-click, and click Delete. To
cancel all operations, select all the operations in the preview list, right-click, and click the
Delete command, or click the Cancel button.
8.
To start the operation(s), click the Apply button. The MCU will automatically begins using the
new logical path for XP Continuous Access activities.
Before deleting a path to an RCU, make sure that the remaining number of paths is equal to or
greater than the minimum number of paths setting (on the RCU Option dialog box). The delete
path operation will fail if the number of remaining paths is less than the minimum number of paths.
The Delete Path command allows you to delete a path to an existing RCU.
To delete a path from the connected MCU to an existing RCU:
1.
Open the RCU Option dialog box, and check the Minimum Paths setting. If the remaining
number of paths is less than this value, the delete path operation will fail. If needed, change
the Minimum Paths RCU option so that you can delete the desired path.
2.
Click the RCU Operation tab, and click the MCU&RCU display button.
3.
Select and double-click on the desired MCU CU in the tree, and select the RCU for which you
want to delete path(s). Alternatively, select the RCU in the list, right-click, and click Edit SSID(s)
& Path(s). All paths to the selected RCU are listed.
4.
Right-click the path(s) that you want to delete, and then click Delete Path. When a confirmation
message appears, click OK to delete the paths, or click Cancel to cancel your request to delete
them. The preview list displays the path(s) that you want to delete. Delete is displayed in the
right-most column of the selected path in the SSID/Path list.
5.
Verify the requested operation(s) displayed in the preview list and the SSID/Path list.
To delete all paths to the selected RCU, click Apply .
If you do not want to delete all paths to the selected RCU, remove the path(s) that you do not
want to delete as follows: select the path, right-click, and click Delete.
To cancel all operations, select all the operations in the preview list, right-click, and click the
Delete command, or click the Cancel button.
6.
To start the operation(s), click the Apply button.
Adding and Deleting SSIDs for an RCU
Before adding an SSID, make sure that the remote copy connection is properly installed. You can
add three SSIDs to each RCU. Before deleting an SSID, make sure that the remaining SSIDs are
still valid, because the connection between the MCU and RCU may be lost. This function is not
available for CU Free.
The Add SSID dialog box (see
) allows you to add up to three SSIDs to an
existing RCU. To open the Add SSID dialog box, click the MCU&RCU display on the RCU Operation
window, select and double-click on the desired MCU CU in the tree, select the desired RCU,
right-click the RCU, and then click the Add SSID command.
92
Performing XP Continuous Access Configuration Operations