HP NonStop G-Series - Manual (Page 102)

Managing Tape Drives
L700 (CTL700) Installation and User’s Guide — 527338-004
9 -2
Checking the Status of the Tape Devices
Object-spec
Specifies one of the following combinations of object type and object
name:
Wild-card characters are supported.
STATUS SCSI Command
This subsection describes the STATUS SCSI command for Open SCSI devices.
The command syntax is:
$ device-name
specifies the name of the Open SCSI I/O process.
-P | -B
specifies whether the path is the primary (-P) or the backup (-B).
DETAIL
returns all status information.
Examples Using STATUS SCSI
These examples illustrate the STATUS SCSI command:
•
To display the status of all Open SCSI devices on the system, type:
-> STATUS SCSI $*
•
To display the summary status of the Open SCSI device $DEV00, type:
-> STATUS $DEV00
•
To display the detailed status of the Open SCSI device $DEV00, type:
-> STATUS $DEV00, DETAIL
•
To display the summary status of the backup path of the Open SCSI device
$SD00, type:
-> STATUS $SDOO-B
Object Type Object Name
SCSI $device-name
SCSI $device-name-path
SUBSYS $sto-mgr
TAPE $tape-name
STATUS SCSI $ device-name [ -P | -B ]