Figure 6-1, Removing the cap magazine – HP NonStop G-Series User Manual
Page 81
Operating the Tape Library
L700 (CTL700) Installation and User’s Guide — 527338-004
6 -5
Entering Cartridges Through the CAP
4. Enter the cartridges into the magazine so they lie flat, with the bar code up and the
reel facing away from you.
5. Return the magazine to its closed position. (If a retention cover is used on the
magazine, remove the cover before replacing.)
6. Press the CAP A or CAP B button on the operator panel to close the CAP.
Figure 6-1. Removing the CAP Magazine
Note.
The snap-on retention cartridge cover can be used to keep cartridges in place when you
carry the magazine. Remove the clear cover from the back of the magazine by lifting the side
edge. To protect the cartridges, place the slots on one edge of the cover into the grooves on
the sides of the magazine’s top panel and snap the other edge into place.
Caution.
Remove the retention cover before loading the magazine into the CAP.
Note.
It is strongly recommended that unlabeled cartridges not be entered into the CAP.