HP NonStop G-Series - Manual (Page 98)

Configuring the CTL700 Tape Library for the
NonStop S-Series Server
L700 (CTL700) Installation and User’s Guide — 527338-004
8 -2
Adding the Control Path and the Data Path
Adding the Control Path and the Data Path
ServerNet/DA
To add the control path to the server configuration database, use the SCF ADD SCSI
command. Use the SCF ADD TAPE command to add the data path.
Before issuing
these commands, check that the tape drive(s) and tape library are installed
properly.
To add the control path:
-> SCF
-> ADD SCSI $CTL700, SENDTO STORAGE, PRIMARYLOCATION
(1,1,51), PRIMARYSAC 1, SCSIID 5, PRIMARYCPU 0, BACKUPCPU 1
-> START SCSI $CTL700
-> STATUS SCSI $CTL700, DETAIL
To add the data path:
-> SCF
-> ADD TAPE $TAPE0, SENDTO STORAGE, LOCATION (1,1,51), SAC
1, DEVICEID 5, PRIMARYCPU 0, BACKUPCPU 1
-> START TAPE $TAPE0
-> STATUS TAPE $TAPE0, DETAIL
For complete details about the ADD and STATUS commands, including
command syntax, see the SCF Reference Manual for the Storage Subsystem.