HP OneView - Manual (Page 282)

After the networks are added, when you select a network in the master pane , you can see details
about that network in the details pane. For each of the networks you created:
•
The value for Uplink Set is none because you have not yet defined an uplink set that uses this
network. You will define the logical interconnect and its uplink sets in
“Creating a logical
interconnect group and its uplink sets” (page 286) .
•
The value for Used by is none because there are no server profiles or storage systems using
this network. You will define a server profile in
“Creating a server profile to use as a template”
(page 295) . You will create a storage system in “Adding a storage system to the data
center” (page 306) .
The following figure shows the Networks screen after you add the Fibre Channel networks.
Actions
All statuses All types All labels Reset Networks 4
Create network
Overview FC 4
General
Type
Associate with SAN
SAN manager
Preferred bandwidth
Maximum bandwidth
Uplink Set
Login redistribution
Link stability interval
Used by no server profiles
no storage systems
Auto
30 seconds
2.5Gb/s
10Gb/s
none
none
none
Fibre Channel Fabric attach
V V V
V V
Name
FC 1 FC
VLAN Type
FC 2 FC
FC 3 FC
FC 4 FC
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
A.5.3.2 Configuring the Ethernet networks
1. From the main menu , select Networks, and then click + Create network in the master pane .
The Create network dialog box opens.
2. Create the ESXi management and vMotion networks:
a.
For Name, enter mgmt 1131.
b. For Type, select Ethernet.
c. For VLAN, select Tagged.
d. For VLAN ID, enter 1131.
e. For Purpose, select Management.
f. For Preferred bandwidth and Maximum bandwidth, use the default values.
g. Select Smart link, but do not select Private network.
Smart link specifies that if all of the uplinks to this network within an uplink set fail, server
connections that specify this network report an error. This feature enables the server
software to detect and respond to an uplink failure. It can be helpful when using certain
server network teaming (bonding) configurations.
h. Click Create + to create another network.
The appliance creates the network and opens the Create network dialog box. This dialog
box uses the configuration values you selected in the preceding steps, except for the name
and VLAN ID.
Behind the Create network dialog box, you might see the networks you create listed in
the
master pane of the Networks screen as those networks are added.
i. For Name, enter vmotion 1132.
j. For VLAN ID, enter 1132.
282 Step by step: Configuring an example data center using HP OneView