HP NetRAID-4M Controller - Manual (Page 139)

6-33
Working with Container Attributes
In the example, the State column indicates container 0 is being used
as a Copy container in a
container reconfiguration
operation. (Note that the example eliminates some items in the
container list display to make the example readable on this
page.)
HPN0> container list /full=TRUE
Executing: container list /full=TRUE
Cluster Num Total Oth Stripe Scsi Partition
Dr Partner Label Type Size Ctr Size Usage C:ID:L Offset:Size State
-- ------- ----- ------ ------ --- ----- ------ ------ ------------ ----
0 0 Volume 100MB None 2:01:0 Copy
Displaying the Reconfiguration Destination Container State
The reconfiguration destination container state
attribute indicates that a container is being used as the destination
container, which is a hidden container used during a
container
reconfiguration operation.
To display whether a container is the destination container in a
container reconfiguration operation, use the container
list command with the /full switch, as in the following example.
In the example, the State column indicates Dest, which means that
container 62 (a hidden container) is being used as a destination
container in a
container reconfiguration operation. (Note
that the example eliminates some items in the container list
display to make the example readable on this page.)
HPN0> container list /full=TRUE
Executing: container list /full=TRUE
Cluster Num Total Oth Stripe Scsi Partition
Dr Partner Label Type Size Ctr Size Usage C:ID:L Offset:Size State
-- ------- ----- ------ ------ --- ------ ------ ------ ----------- ----
0 0 Reconf 100MB None
0 62 Stripe 100MB 32KB None 2:01:0 64.0KB: 100MB Dest
0 63 Volume 100MB None 2:01:0 64.0KB: 100MB Source
0 61 Stripe 1.00MB 32KB None 2:01:0 8.47GB:1.00MB Temp
Displaying the Reconfiguration RAID-5 Set Container State
The reconfiguration RAID-5 set state attribute indicates
that a container is being used as a RAID-5 set in a container
reconfiguration operation.
To display whether a container is being used as a RAID-5 set in a
reconfiguration operation, use the container list
command with the /full switch, as in the following example. In