HP StorageWorks XP Remote Web Console Software - Manual (Page 108)

220 * 1 FFFF FFFF 01 PATH ESTABLISHED... *
220 * ---- ---- 00 NO PATH............ *
220 * ---- ---- 00 NO PATH............ *
220 * ---- ---- 00 NO PATH............ *
220 * SUBSYSTEM WWNN LIC LEVEL *
220 * ----------- ---------------- ----------- *
220 * PRIMARY.... 0000000000000000 80.9.6.255 *
220 ********************************************************************
14.27.59 JOB04573 ANTP0001I CQUERY COMMAND COMPLETED FOR DEVICE 6400. COMPLETION CODE: 00
The following is an example of the PPRCOPY QUERY command. When a command is issued to the target
volume (T-VOL) in a consistency group, the field for displaying the serial number of SECONDARY is
output in the following format:
00|S|@|000|30158
The following is an example of the Status display, which is the same as the CQUERY TSO command.
0
0 PPRCOPY QUERY UNIT(6400)
-ICK00700I DEVICE INFORMATION FOR 6400 IS CURRENTLY AS FOLLOWS:
- PHYSICAL DEVICE = 3390
- STORAGE CONTROLLER = 2105
- STORAGE CONTROL DESCRIPTOR = E8
- DEVICE DESCRIPTOR = 0A
- ADDITIONAL DEVICE INFORMATION = 4A000035
- TRKS/CYL = 15, # PRIMARY CYLS = 3339
0ICK04030I DEVICE IS A PEER TO PEER REMOTE COPY VOLUME
0
0 QUERY REMOTE COPY - VOLUME
0
(PRIMARY) (SECONDARY)
SSID CCA SSID CCA
DEVICE LEVEL STATE PATH STATUS SER # LSS SER # LSS
0------ --------- -------------- ----------- ----------- -----------
6400 PRIMARY DUPLEX ACTIVE 2700 00 2700 01
63515 00 63515 00
0
PATHS SAID/DEST STATUS DESCRIPTION
----- --------- ------ ----------------
1 FFFF FFFF 01 PATH ESTABLISHED
0
0
-ICK02206I PPRCOPY QUERY FUNCTION COMPLETED SUCCESSFULLY
The DEVSERV command can also be used to display Siz pair status. The following is an example of the
DEVSERV command. See Table 26 on page 107 for a description of the DEVSERV command results
for Siz volumes.
97244 13:04:38.57 IEE459I 13.04.37 DEVSERV PATHS 692
692 UNIT DTYPE M CNT VOLSER CHPID=PATH STATUS
692 RTYPE SSID CFW TC DFW PIN DC-STATE CCA DCA
692 DE80,33903 ,0,000,DKDE80,54=+ 1C=+ D4=+ 9C=+
692 0080 Y YY. YY. N PPRIMARY 00 00
Siz supports multiple T-VOLs for an S-VOL, and Siz and TCz can both be defined for the same volume.
When multiple pairs exist on one volume, the CQUERY and PPRCOPY QUERY commands can only report
the status of one pair. Table 27 on page 109 lists the status displayed by the host for the Siz and/or TCz
volume pair configurations.
• If the storage system contains only Siz pairs, the CQUERY and PPRCOPY QUERY commands
report the Siz pair status.
• If the storage system contains only TCz pairs, the CQUERY and PPRCOPY QUERY commands
reports the TCz pair status.
108 Using PPRC Commands for Hitachi ShadowImage for z/OS