Resetting the reserve attribute, 33 set reserve attribute dialog box (reserve), Figure – HP StorageWorks XP Remote Web Console Software User Manual
Page 73: Figure 33
Figure 33 Set Reserve Attribute Dialog Box (Reserve)
The Set Reserve Attribute dialog box displays the unreserved simplex volume(s) that you selected on
the Siz main window.
The OK button allows you to set the reserve attribute for unreserved volume(s).
NOTE:
The setting(s) are displayed in the Preset List on the Siz main window. The Cancel button closes the Set
Reserve Attribute dialog box without reflecting the settings. To apply the settings to the HP StorageWorks
XP12000 storage system, click the Apply button on the Siz main window.
To reserve one or more volumes for use as Siz T-VOLs (by setting the reserve attribute):
1.
From the host, set the volume(s) that you are reserving to offline. The HP StorageWorks XP12000
storage system rejects all read/write I/Os to reserved volumes (except when in the split status).
2.
On the Siz main window, select the desired CU image or LDEV in the Tree.
3.
Display unreserved simplex volumes in the Volume List (e.g., to display unreserved simplex
volumes, clear the Reserve and Pair check boxes, and click the Non-Pair check box on the
Display Filter dialog box).
4.
Select the desired volume(s), right-click the mouse to display the pop-up menu, and then click
the Change Reserve command. The Set Reserve Attribute dialog box opens. If the Change
Reserve command is not enabled, you selected paired volumes. Select only unreserved and
unpaired simplex volumes.
5.
On the Set Reserve Attribute dialog box, select the volume(s) you want to reserve, and then click
the OK button. The setting is reflected in the Preset List box on the Siz main window.
6.
On the Siz main window, click the Apply button.
7.
Verify that the settings are reflected in the HP StorageWorks XP12000 storage system.
NOTE:
You can check whether the attribute setting is updated or not on the Display Filter dialog box. To open
the Display Filter dialog box, click the Display Filter button.
Resetting the Reserve Attribute
The Reset Reserve Attribute dialog box (see
on page 74) allows you to reset the reserve attribute
for (i.e., unreserve) the volume(s) selected on the Siz main window. To open the Reset Reserve Attribute
Hitachi ShadowImage for z/OS user guide
73