HP StorageWorks XP Remote Web Console Software User Manual
Page 77
grayed out when the total number of volumes defined in the storage system is less than 1,024
volumes.
• The Next button allows you to turn to the next page of the T-VOL List. This button is selectable
only when the number of volumes defined in the storage system exceeds 1,024 volumes, which
is the maximum number of volumes that can be displayed on one page. It remains dimmed
when the total number of volumes defined in the storage system is less than 1,024 volumes.
• The T-VOL List displays the following information related to T-VOLs:
• Volume: The ID (CU:LDEV) of the T-VOL.
• Type: The emulation type of the T-VOL.
• Capacity(CYL): The capacity of the T-VOL (the number of cylinders).
• CLPR: The cache logical partition (CLPR) of the T-VOL.
•
The Set button adds the selected T-VOL and S-VOL to the Add Pair Volume List as a new Siz pair.
•
The Change button replaces the T-VOL of the selected pair in the list with the selected T-VOL.
•
The OK button adds the operation (setting) to add a new pair using the S-VOL and T-VOL you
selected in the Add Pair Dialog box to the Preset List on the Siz main window.
NOTE:
To apply all the new pair operation settings displayed in the Preset List to the HP StorageWorks
XP12000 storage system, you must click the Apply button on the Siz main window.
•
The Cancel button cancels the operations set in the Add Pair Dialog box and closes the Add
Pair dialog box.
To remove any volumes from the Add Pair Volume List or the T-VOL List, select the volumes, right-click
the selected volumes using the mouse, and then click the Delete command from the pop-up menu that
appears after right-clicking.
If you want to add new Siz pairs and then split them immediately so that you can access the T-VOLs as
soon as possible, use the Split Pair operation instead of the Add Pair operation to establish and split new
pairs at the same time (see section“
” on page 82 for instructions).
To add one or more new Siz pairs:
1.
Make sure that the desired T-VOL(s) is/are offline (see section
2.
Go to the Siz main window, and select the desired CU image or S-VOL in the Tree to filter the
volumes displayed in the Volume List.
3.
Select the desired S-VOL(s) for the new pair(s), right-click the mouse to display the pop-up menu,
and then click the Add Pair command to open the Add Pair Dialog box.
NOTE:
Do not select any reserved volumes as S-VOLs.
4.
On the Add Pair Dialog box, select the initial copy pace (Slower, Medium, or Faster) from the
Copy Pace drop-down list for all pairs being added.
5.
Verify that the Add Pair Dialog box displays the desired S-VOL(s). If you want to remove any
volumes from the list, select the volume(s), right-click the mouse to display the pop-up menu,
and then click the Delete command.
6.
Select the T-VOL(s) for each S-VOL as follows:
a.
Select the desired S-VOL from the Add Pair Volume List on the Add Pair Dialog box.
b.
Select the desired CU image from the CU drop-down list in the Select T-Vol box. Then click
the Reserved check box to display reserved volumes, and then select from the reserved
Hitachi ShadowImage for z/OS user guide
77