HP Business Inkjet 2600 Printer series - Manual (Page 49)

ENWW 5-9
Resetting the HP Jetdirect print server
Resetting the HP Jetdirect print server restores print server to the
factory default values.
Note All previously stored EIO settings will be lost.
To reset the HP Jetdirect print server
1 Turn off the printer.
2 While holding down both I TEM and R ESUME on the LCD control
panel, turn on the printer.
CFG LINK NO
YES Selects whether you want to manually
configure the HP Jetdirect 10/100Base-
TX print server’s network link speed and
communication mode. The HP Jetdirect
settings must match the network. The
default setting is
NO , which bypasses
the link configuration menu items.
If you specify
CFG LINK=YES , you can
select one of the following link
configuration menu items:
! AUTO (default): The print server
automatically configures itself to
match the link speed and
communication mode of the
network.
! 10T HALF : 10 Mbps, half-duplex
operation
! 10T FULL : 10 Mbps, full-duplex
operation
! 100T HALF : 100 Mbps, half-duplex
operation
! 100T FULL : 100 Mbps, full-duplex
operation
Message Value Description