HP Business Inkjet 2600 Printer series - Manual (Page 70)

7-10 ENWW
To load the front manual feed
1 Slide the paper width guide on the output tray to its outermost
position.
2 Insert the media along the right side of the front manual feed, print-
side down. Push the media in until it reaches the maximum depth.
3 Slide the paper width guide to fit snugly against the media.
4 In the printer driver, select Manual Feed as the media source, and
then select the type of media.
5 When prompted, press R ESUME on the LCD control panel.
To load the rear manual feed
1 If an auto-duplex unit is installed in the printer, remove it and
reinstall the rear manual feed:
a While pushing the auto-duplex unit release buttons, slide the
auto-duplex unit out of the printer.
b Slide the rear manual feed into the back of the printer.
2 Insert a single sheet of media vertically (portrait orientation) along
the left side of the rear manual feed. The media should be print-side
up.
3 Push the media into the printer.
When the printer sensors detect the media, the printer will pull the
media slightly farther into the printer.
4 In the printer driver, select Manual Feed as the media source, and
then select the type of media.
5 When prompted, press R ESUME on the LCD control panel.