HP Business Inkjet 2600 Printer series - Manual (Page 80)

7-20 ENWW
To print on custom-sized paper from tray 1 or tray 2
1 Load the media in tray 1 or tray 2. (For more information, see “Load
paper and configure media types and sizes.”)
2 In the printer driver, select Tray 1 or Tray 2 as the media source,
and then either select or create a custom size.
3 Print the document.
Printing on both sides of the page
The printer can automatically print on both sides of paper with an
optional auto-duplex unit.
Note Make sure the auto-duplex unit has been configured in the printer driver
you are using. For more information, see “Enable the HP Auto-Duplex
Unit in the printer driver (optional).”
Guidelines for printing on both sides of a page
When printing on both sides of the page using the optional auto-duplex
unit, use the following guidelines:
! The auto-duplex unit supports the following paper sizes:
U.S. Letter, U.S. Legal, U.S. Executive, A4, JIS B4, JIS B5, 11 x 17,
A3, and Super B (13 x 19 inches). It does not support smaller sizes
or custom sizes.
! The minimum top margin should match or exceed 12 mm
(0.5 inch).
! Do not print on both sides of transparencies, envelopes, plain
premium inkjet paper, photo paper, brochure paper, or paper lighter
than 60 g/m
2
(16 lb Bond) or heavier than 105 g/m
2
(28 lb Bond).
Jams might occur with these types of media.
! To print on both sides of paper, make the selection from the
software or printer driver. (For Windows, see the printer driver
online help. For Macintosh, see the Mac Help on your computer.)
! If you do not use the printer driver that came with the printer, you
might need to change the Duplex setting from the Configuration
Menu in the LCD control panel to
DUPLEX=ON . Also, in the
Configuration Menu, set Binding to long edge or short edge. For
information about using the LCD control panel, see “Using the LCD
control panel.”