Ag Leader Integra Users Manual - Manual (Page 44)

28 Firmware Version 5.4
Starting an Event
1. Press: Select Event button.
Select a Season, Grower, Farm, and
Field on the Management Selection
screen.
Note: This screen does not appear when operating
in Events Only mode.
Enable Management button
is checked by default and requires a Grower, Farm,
and Field to be entered before proceeding.
To create a Grower, Farm, and Field press the
button on current screen and press
again next screen. Then type in name and press
twice.
Grower, Farm, and Field can also be created in
Management setup . See “Grower/Farm/Field
tab” on page 30 to set up information using Management setup.
Un-checking Enable Management button will allow operator to continue to next
screen without entering additional information on this screen (similar to Events Only mode).
Next screen will vary depending on configuration.
For Example:
The screen shown to the left will appear for
Guidance configurations.
For Application configurations the screen will involve
product selection.
For Seeding configurations the screen will involve
seed selection.
Make selections and press to continue.
Map screen will appear and user can begin
operation.
Managing Events
Edit Event Name, Suspend Event, and Clear Map Bounds
Press Setup
button (wrench)
on Event bar.
Select Event
2014 Crop
Growing Season
Grower
George Eilers
Farm
Sheldon
Field
Management Selection
Enable Management
Orab
Enable Management
Enable Management
Pattern Options
New Guidance Pattern
Change
Pattern
Implement Width:
Guidance Width
30.0000
30.0000
Enable Tramlines
Straight
Event: 2014-01-09_14:40:42
Grower: George Eilers
Farm: Sheldon Field: Orab