American Fibertek Scout SS1 - Manual (Page 13)

13
Installation
To install the Scout it is first necessary to mount the rack
flanges to the unit. Two mounting flanges are supplied
with each scout. For flush mounting, install the ears with
the #10 flathead screws provided
For rack mounting the ears are installed on the sides of
the unit with the surfaces that have oval holes flush
with the front of the unit as in Figure 1. Mount the ears
with the #10 flathead screws provided. To mount in
the rack cabinet, use mounting screws that are
appropriate for the rack cabinet being used.
Power Source
The internal power supply accepts universal line voltage. Any mains supply from (85 to 264
VAC), (47 to 63 Hz) may be used without modification or adjustment. A universal power
connector is provided on the rear of the unit to facilitate connection to the power mains.
Power Connection
The unit is supplied (in the US and UK only) with a three conductor power cord. The “ground”
conductor is directly connected to the chassis.