American Fibertek Scout SS1 - Manual (Page 29)

29
Logging In & Out
After entering Scout’s IP address (default
IP address in the case of start up) the log
in screen will appear. If the location has
been previously titled, that name will
appear.
Entering the User Name and Password will
define your access level to Scout. After
entering your user name and
password press Submit.
Log In Exceeded:
Scout allows three attempts to enter the correct User Name and Password. If on the fourth attempt
the correct name and password are not entered the following message will appear. Retries can be
attempted after a time out period.
When the number of allowable retires is exceeded, the invalid log attempts will be recorded in the
access log showing the date, time and IP address source
Logging Out:
The icon in the upper right hand corner of the screen is used to log out of Scout. Point and click
on the icon to log off. The icon will appear in all operation and programming screens allowing the
log out function at any time.
Auto Logging Out:
If no activity has occurred in twenty (20) minutes, Scout will automatically log out as a security
precaution. To avoid this after programming is complete, leave Scout operating in Status View
mode with a programmed refresh rate. .
As a result of pressing the Log Out icon a pop
up will appear asking if you are sure.
Press OK to log out. Press Cancel to return to
the previous screen.