American Fibertek Scout SS1 - Manual (Page 20)

20
Reset to factory Defaults
If the Master Admin password and user name is changed and lost for any reason, the only
recovery method is to reset Scout back to its defaults. For this reason the following precautions
should be taken:
1. Keep a record of all user names and passwords. IT and Security user names and passwords
are maintained by and can be accessed by the Master Admin. However the Master
Admin user and password is not.
2. Follow the procedures on page 62-63 to download and save programmed settings. If a
Scout reset is required all programming will be returned to its default settings. By saving
programming a Master Admin can perform a Restore, returning Scout to its programmed
functions.
3. Save all existing logs by performing either a Save As to a client computer or by emailing
logs. Please note: once a unit is reset to defaults or powered down all log information is
erased.
To Reset Scout: Locate the recessed button on the rear panel
(As a precaution the procedure must be performed during power up)
Apply power to Scout. Wait approximately one minute.
The Port A LED will change to Amber, meaning program is waiting for instruction.
Press the reset button for 10 seconds, the Port B LED will turn amber.
Hold the reset button for 2 full seconds longer.
When both Port A and B turn off at the same time the system has reset to its defaults.
This procedure must be followed exactly. If the procedure is not followed as stated, the Port A
LED will turn off after 10 seconds and will not allow any more attempts to reset until power is
cycled.
Factory Default Settings:
Global Admin Login (Case Sensitive):
User:
Admin
Password: Password
IP Address: 192.168.0.246 (Before firmware 20110504: 192.168.10.11)
Net Mask: 255.255.255.0
Gateway: 192.168.0.143 (Before firmware 20110504: 192.168.10.1)