American Fibertek Scout SS1 - Manual (Page 67)

67
Sensor Probe Setup: Programming the Auxiliary Duration Setting
The Auxiliary Duration settings will only appear once a probe has been selected.
The Duration provides a setting ranging from 0 Sec- Indefinitely
0 Sec = no auxiliary response occurs.
10 Seconds to 4 Hours = Auxiliary will remain active for the programmed
duration.
Follow = the auxiliary duration will follow the same duration of the active
warning or alarm. The auxiliary start point will be 30 Seconds after the start of
the event and end 30 seconds after the event has ended.
Indefinitely = the Auxiliary will remain active until the operator extinguishes it
via the Status View mode.
Duration Theory of Operation:
Programming the auxiliary duration acts independent of entries made to the Event Log.
Regardless of programmed auxiliary the event log will record the actual start time and actual end
time of the event.
An operator can terminate any auxiliary output but clicking on the active auxiliary in the Status
View mode. Regardless of manually terminating an auxiliary event the event log will record the
actual start time and actual end time of the event.
Aux Action 2: See Aux Action 1
Duration: See Duration 1
Alarm Level: Log, Alert, Email, Aux Action 1, Duration, Aux Action 2, and Duration all operate
in the same manner as Warning.