ATEN ALTUSEN KM0832 - Manual (Page 100)

KM0832 User Manual
84
(continued from previous page)
Setting Function
SET PORT ID A submenu appears with three selections:
ID POSITION—Allows you to position where the port ID appears
on the monitor. The default is the upper left corner, but you can
have it appear anywhere on the screen.
Use the mouse or the arrow keys plus [Page Up], [Page Down],
[Home], [End], and [5] (on the numeric keypad with [Num Lock]
off), to position the port ID display, then double-click or press
[Enter] to lock the position and return to the View submenu.
DISPLAY DURATION—Determines how long a port ID displays
on the monitor after a port change has taken place. The choices
are:
USER DEFINED—which lets you select the amount of time
(from 1–240 sec.); and
ALWAYS ON—which displays the port ID at all times. If you
select User Defined, key in the number of seconds, then
press [Enter]. The default is 3 seconds. A setting of 0 (zero)
disables this function.
DISPLAY MODE—Selects how the port ID is displayed: the port
number plus the port name (PORT NUMBER + PC NAME); the
port number alone (PORT NUMBER); or the port name alone
(PC NAME). The default is PORT NUMBER + PC NAME.
SET SCAN SCAN INTERVAL—Determines how long the focus dwells on
each port as it cycles through the selected ports in Auto Scan
Mode (see F7 SCAN, p. 97). Key in a value from 1–240 seconds,
then press [Enter]. The default is 5 seconds; a setting of 0
disables the Scan function.
SCAN MODE—Selects which computers will be accessed under
Auto Scan Mode (see F7 SCAN, p. 97). Choices are:
PERSONAL—only those ports that the user has set as
personal. See SET PERSONAL VIEW on p. 83.
ACCESSIBLE—only those ports that the user is permitted to
access. See PORT ACCESS, p. 90.
ACCESSIBLE + POWERED—only those ports that the user is
permitted to access and that have their attached computers
powered on.
The default is Accessible + Powered.