ATEN ALTUSEN KM0832 - Manual (Page 46)

KM0832 User Manual
30
Setting the IP Address
You can use a Web browser, the IP Installer, or the OSD to configure the
KM0832 for deployment on your local network. To use a Web browser to
configure the KM0832 you will need a computer equipped with a Web
browser, an Ethernet hub with at least 2 ports, and 2 Cat 5 patch cables.
To configure the network settings via a Web browser:
1. Plug one end of a Cat 5 patch cable into the Ethernet hub and the other end
into the CONFIGURATION port on the rear panel of the KM0832.
2. Plug one end of a Cat 5 patch cable into the Ethernet hub and the other end
into the Ethernet adapter of a computer equipped with a Web browser.
3. Make sure that your computer’s IP address lies within the same subnet as
that of the KM0832. (The default IP address for the KM0832 is
192.168.0.10.) Set the IP address for your computer’s network adapter to
192.168.0.XXX, where XXX represents any value from 1–254 (except 10
and 254, which are reserved for the KM0832). (See Factory Default
Settings, page 108, for a list of the KM0832’s default network settings.)
Note: If you are using a proxy server, you might need to modify your
computer’s proxy server settings before accessing the KM0832.
4. Enter 192.168.0.10 in your Web browser’s address bar. The KM0832
Login Webpage appears.
5. After logging in, assign a new IP address to the KM0832 that is
appropriate for your local network. (See Network Configuration, page 38).
6. After logging out, reset your computer's network adapter settings back to
their original values.
To configure the network settings via the IP Installer:
Go to the Altusen homepage and select the Webpage that is specific for the
KM0832. From there you can download the IP Installer along with instructions
on how to use it to assign an IP address to the KM0832.
To configure the network settings from within the OSD:
1. From the console, open the OSD. Navigate to the IP ADDRESS SET-
TING screen (see SET NETWORK, page 94).
2. Follow the instructions in this user manual to manually set the IP address
or to view the current settings. (If DHCP is enabled, you will not be able to
view the IP address.)