ATEN ALTUSEN KM0832 - Manual (Page 117)

Chapter 5. Hotkey Operation
101
Auto Scanning
Auto Scan switches among all the KVM ports that are accessible to the current
operator at regular intervals (see SCAN MODE under SET SCAN, p. 84, for
information regarding accessible ports). This function is convenient for
automatically monitoring the activity of the computers on the installation.
Setting the Scan Interval:
The amount of time Auto Scan focuses on each port is set with the SCAN
INTERVAL setting of the OSD F2 SET function (see SET SCAN on p. 84). You
can change the scan interval before activating Hotkey Auto Scanning, if you
wish, with the following Hotkey combination:
1. Invoke HKM (see p. 99).
2. Key in [T] [n]
Where [T] is the letter T, and [n] is a number from 1–255 that represents
the number of seconds for the dwell time.
The letter T and the numbers display on the command line as you key
them in. If you make a mistake, use [Backspace] to erase the wrong
number.
3. Press [Enter]
After you press [Enter], you automatically exit HKM, and are ready to
invoke Auto Scanning.