Horner APG XLt OCS HE-GSM04 - Manual (Page 38)

PAGE 38 GPRS / GSM MODEM Configuration MAN4005-04-EN
SMS Message Configuration
Trigger Variable Settings
An event is needed to trigger a SMS communication from the controller to the member(s) of a
Group. Enter a bit reference in the Address field that (when set to HIGH) causes the SMS
message associated with the trigger to be sent to the specified Group member(s). The
application code should make the bit high. It will be made low by the firmware once the SMS
send request is serviced. An I/O name can be entered or selected in the Name field.
Message Attributes Enter or select the group that the SMS message is sent to.
SMS Message
Configuration
Messages can contain text and register data values that approved group members can read
and write into the controller's data registers at runtime. See Rules for Send and Receive
Messages.
•
The text of the message is entered starting in the upper most left block of the text
input field (shown in green).
•
In order to edit/add register data values, click F2 = Edit Field button and configure
the Insert Value Field screen shown below:
5.2.8 Insert Value Field
Insert Value Field
Value Variable Settings
Enter a register reference where the data embedded in the message to send will be stored. An I/O
name can be entered or selected in the Name field. Select Register Width.
Other Settings
Select or enter the data type in the Display Format field. In the Decimal Position field, click the
position of the decimal point. Click the number of digits in the Number of Digits.
Example: xx.xx shows that the decimal is in the 3rd position and the total number of digits
(including the decimal) is 5.
Click the Fill Zeroes box and the Left Justified or Right Justified box if desired.
Page 38 of 62 ECN # 956