Horner APG XLt OCS HE-GSM04 - Manual (Page 60)

PAGE 60 GPRS / GSM MODEM Configuration MAN4005-04-EN
26. $AREG Auto Registration
$AREG Auto Registration
Command Function This command sets the auto registration state of the modem
Command Functional
Group Enfora specific
Command Format Query
Response AT$AREG=?
$AREG: (0,2)
OK
Write Format
Response AT$AREG=<state>
OK
Read Format
Response
AT$AREG?
$AREG: <state>
OK
Execution Format
Response N/A
N/A
Parameter Values
0 Autoreg off
1 Autoreg on
<state>
2 Auto GPRS Activation on Power up. (for $hostif=1 and 2, MT will perform
GPRS activation and go into PAD data mode. For Hostif=0 and 3, MT will
perform GPRS activation, but remain in AT command mode)
Notes
This command sets GMS registration state.
When set to 1, upon power on, the modem will automatically register on the GSM
network. To set the modem to automatically attach to the GPRS network on power
on, see AT%CGAATT command.
AT+CGDCONT must be entered and saved before MT is placed in AREG=2.
* If PIN is enabled, the modem will not complete the auto registration process
until after the PIN has been entered (AT+CPIN).
27. $HOSTIF Configure Host to Modem Interface
$HOSTIF Configure Host to Modem Interface
Command Function This command allows the user to configure the desired Host to Modem interface.
This parameter determines the behavior of the ATD command.
Command Functional
Group Enfora Specific
Command Format Query
Response AT$HOSTIF=?
(0-3)
Write Format
Response AT$HOSTIF=<host interface>
OK
Read Format
Response AT$HOSTIF=?
HOSTIF: <host interface>
Execution Format
Response N/A
N/A
Parameter Values
0 = Establish normal external Dial up networking modem to network connection.
1 = Establish UDP PAD session. Upon establishment of a network activation, a
CONNECT message will be displayed. “No Carrier” or error will indicate failed or
terminated UDP PAD session.
2 = Establish TCP PAD session Upon establishment of a network activation, a
CONNECT message for at$active=1, or a LISTEN message for at$active=0 will
be displayed. “No Carrier” or error will indicate failed or terminated TCP PAD
session.
<host interface>
3 = Establish non-GPRS PPP connection.
Page 60 of 62 ECN # 956