Horner APG XLt OCS HE-GSM04 - Manual (Page 41)

MAN4005-04-EN GPRS / GSM MODEM Configuration PAGE 41
7 Installation / Safety
Warning: Electrical
Shock Hazard.
When found on the product, the
following symbols specify:
Warning: Consult
user documentation.
WARNING: To avoid the risk of electric shock or burns,
always connect the safety (or earth) ground before making
any other connections.
WARNING: To reduce the risk of fire, electrical shock, or
physical injury it is strongly recommended to fuse the voltage
measurement inputs. Be sure to locate fuses as close to the
source as possible.
WARNING: Replace fuse with the same type and rating to
provide protection against risk of fire and shock hazards.
WARNING: In the event of repeated failure, do not replace
the fuse again as a repeated failure indicates a defective
condition that will not clear by replacing the fuse.
WARNING: Only qualified electrical personnel familiar with
the construction and operation of this equipment and the
hazards involved should install, adjust, operate, or service this
equipment. Read and understand this manual and other
applicable manuals in their entirety before proceeding.
Failure to observe this precaution could result in severe bodily
injury or loss of life.
‰ All applicable codes and standards need to be followed in
the installation of this product.
8 Technical Support
‰ Adhere to the following safety precautions whenever any
type of connection is made to the module:
9 ƒConnect the safety (earth) ground on the power
connector first before making any other connections.
9 ƒWhen connecting to electric circuits or pulse-initiating
equipment, open their related breakers.
9 ƒDo not make connections to live power lines.
9 ƒMake connections to the module first; then connect to
the circuit to be monitored.
9 ƒRoute power wires in a safe manner in accordance with
good practice and local codes.
9 ƒWear proper personal protective equipment including
safety glasses and insulated gloves when making
connections to power circuits.
9 ƒEnsure hands, shoes, and floor are dry before making
any connection to a power line.
9 ƒMake sure the unit is turned OFF before making
connection to terminals.
9 ƒMake sure all circuits are de-energized before making
connections.
9 ƒBefore each use, inspect all cables for breaks or cracks
in the insulation. Replace immediately if defective.
For assistance, contact Technical Support at the following locations:
EUROPE
Email: [email protected] ,
Fax: +353 (0)21 4321 826
Tel : +353 (0)21 4321 266
Website : http://www.horner-apg.com
USA
Email: [email protected] ,
Fax: +1 317 916 4274
Tel: +1 317 916 4297
Website : http://www.heapg.com
Page 41 of 62 ECN # 956