Avaya 5420 - Manual (Page 36)

2420 and 5420 User Guide
2420 and 5420 User Guide Page 32
IP Office 4.0 15-601077 Issue 8 (11th December 2006)
Changing Function Key Labels
You can replace the default label shown for any function key with you own custom label of up to 13
characters.
1. To exit any other mode, press EXIT and then press Label.

Edit allows you replace the current labels, see the steps below.

Inspect displays the default labels.

Restore replaces any custom labels with the default labels.

Done exits the button labelling options.
2. Press Edit.
3. Select the function key whose label you wish to change.
4. Begin entering the New Label text using the phone keypad:

Each number key is marked with the letters it provides. You may have to press the key
more than once depending on the character required. For example, the key 6 is also
marked as M, N and O. To enter an O, re-press the 6 key until an O is displayed.

If the next character you want is on another key, simply key the next character.

If the next character you want to enter is on the same key just used, press to move the
cursor right and then enter the character.

Press * once enters a . (period). Pressing it twice enters a * (asterix).

Press # once enters a - (dash). Pressing it twice enters a # (hash).

By default the first letter entered and the first letter after any space are entered in upper-
case whilst all other character are entered in lower-case. To change the case of the
current character, press
Case.

To enter a space, press Space.

To move the cursor one space right, press .

If you make a mistake, press Backspace to delete the character to the left of the
cursor.

If you have made a mistake in the middle of a character string and do not wish to
backspace and re-enter all the characters, press to step back to one character before
the point where you wish to edit. Either insert the new character or press
Backspace
to delete the character to the left of the cursor.

To delete all the current text, press Clear.
5. When the new name is set as required, press Save. To return to the label options screen
without saving the changes, press Cancel.
6. Select another button to re-label or press Done.