Sony DCR-TRV50 - Manual (Page 105)

105
Editing
To change the insert end point
Press ZERO SET MEMORY again after step 5 to erase the ZERO SET MEMORY
indicator and begin from step 3.
Using the Remote Commander
In step 5, press z REC and MARK simultaneously, then immediately press X. In step 6,
press X at the scene where you want to start recording from.
Note
Pictures and sound recorded on the portion between the insert start and end points will
be erased when you insert the new scene.
If you insert scenes on the tape recorded on another camcorder (including other
DCR-TRV40/TRV50)
The pictures and sound may be distorted. We recommend that you insert scenes on a
tape recorded on your camcorder.
When the inserted picture is played back
Pictures and sound may be distorted at the end of the inserted portion. This is not a
malfunction.
Pictures and sound at the start point and the end point may be distorted in the LP
mode.
To insert a scene without setting the insert end point
Skip steps 3 and 4. Press x when you want to stop inserting.
If you press FN
The ZERO SET MEMORY indicator is not displayed.
Note on the Remote Commander
Your camcorder works in the commander mode VTR 2. Commander modes 1, 2 and 3
are used to distinguish your camcorder from other Sony VCRs to avoid erroneous
remote control operation. If you use another Sony VCR in the commander mode VTR 2,
we recommend changing the commander mode or covering the sensor of the VCR with
black paper.
Inserting a scene from a VCR – Insert Editing
4
0:00:00
ZERO SET
MEMORY
ZERO SET
MEMORY
5
REC