Sony DCR-TRV50 - Manual (Page 20)

20
Set the date and time when you use your camcorder for the first time. “CLOCK SET”
will be displayed each time that you set the POWER switch to CAMERA or MEMORY/
NETWORK (DCR-TRV50 only) unless you set the date and time settings.
If you do not use your camcorder for about four months, the date and time may be
cleared from memory (bars may appear) because the built-in rechargeable battery
installed in your camcorder will have been discharged (p. 231).
Set the area, the daylight saving time, year, month, day, hour and then the minute, in
that order.
(1) Set the POWER switch to CAMERA or MEMORY/NETWORK (DCR-TRV50
only), then press MENU to display the menu settings.
(2) Turn the SEL/PUSH EXEC dial to select , then press the dial.
(3) Turn the SEL/PUSH EXEC dial to select CLOCK SET, then press the dial.
(4) Turn the SEL/PUSH EXEC dial to select the desired area (where you are), then
press the dial.
(5) Turn the SEL/PUSH EXEC dial to select whether or not the time is daylight
saving time, then press the dial.
Select OFF if the time is not daylight saving time. Select ON if it is.
(6) Turn the SEL/PUSH EXEC dial to select the desired year, then press the dial.
The year changes as follows:
(7) Set the month, day and hour by turning the SEL/PUSH EXEC dial and
pressing the dial.
(8) Set the minute by turning the SEL/PUSH EXEC dial and pressing the dial by
the time signal. The clock starts to move.
(9) Press MENU to make the menu settings disappear.
Step 2 Setting the date and time
1995 T · · · · t 2002 T · · · · t 2079