Sony DCR-TRV50 - Manual (Page 109)

109
Editing
Audio dubbing
Monitoring the new recorded sound
(1) Play back the tape on which you added audio.
(2) Turn the SEL/PUSH EXEC dial to select AUDIO MIX in
in the menu
settings, then press the dial.
(3) Turn the SEL/PUSH EXEC dial to adjust the balance between the original
sound (ST1) and the new sound (ST2), then press the dial.
Five minutes after you disconnect the power supply or remove the battery
pack, the AUDIO MIX setting returns to original sound (ST1) only. The default
setting is original sound only.
Notes
• New audio cannot be recorded on a tape already recorded in the 16-bit mode (32 kHz,
44.1 kHz or 48 kHz).
• New audio cannot be recorded on a tape already recorded in the LP mode.
• You cannot add audio with the DV IN/OUT jack.
• You cannot add audio on the blank portion of the tape.
If an i.LINK cable (DV connecting cable) (optional) is connected to your camcorder
You cannot add audio to a recorded tape.
We recommend that you add audio on a tape recorded with your camcorder
If you add audio on a tape recorded with another camcorder (including other
DCR-TRV40/TRV50), the sound quality may become worse.
If you set the write-protect tab of the cassette to lock
You cannot record on a tape. Slide the write-protect tab to release the write protection.
ST1 ST2
VCR SET
HiFi SOUND
AUDIO MIX
A/V
c DV OUT
RETURN
[MENU] : END