Avaya Media Gateway G250 - Manual (Page 135)

USP Configuration
Issue 5 October 2007 135
The following table provides a list of the fields in the Frame Relay tab of the USP dialog box and
their descriptions:
Table 48: USP Dialog Box - Frame Relay Parameters
Field Description
LMI Type Local Management Interface Type. The Data Link Connection
Management scheme used by the frame relay interface. Possible
values are:
● ANSI
● itu933a
● lmi-rev1
LMI Auto Sense The state of Local Management Interface Auto-Sensing on the
interface. Possible states include:
● Enable - The LMI type is received from the interface at the
other end of the line.
● Disable - The LMI Type is determined by the value in the LMI
Type field.
Operational Status The operational status of the interface. Possible statuses include:
● Up - The interface is up and can transmit and receive
packets.
● Down - The interface is down due to some failure, and cannot
transmit or receive packets.
● Testing - The interface is in testing mode and cannot transmit
or receive regular data.
● Standby - The interface is a backup interface and cannot
transmit or receive packets unless the primary interface it
backs up fails.
● Disabled - The interface is disabled. It cannot transmit or
receive packets.
● Partially Down - The interface is up. However, some
interfaces (or PVCs) layered on top of this interface are
Down. Some packets can be transmitted and received.
MTU (octets) The size (in octets) of the largest datagram that can be sent via the
interface.
1 of 2