Agilent Technologies VXI E1439 - Manual (Page 77)

67
Agilent E1439 Programmer's Reference
Functions listed alphabetically
Functions listed alphabetically
age1439_adc_clock (on page 72)
−determines the ADC clock source
age1439_adc_clock_get (on page 72)
−gets the ADC clock source
age1439_adc_divider (on page 73) −determines which divider is applied to the ADC
clock source
age1439_adc_divider_get (on page 73)
−gets the module's current clock divider state
age1439_attrib_get (on page 74)
−gets low-level attributes of current I/O library session.
age1439_cal_get (on page 75)
−gets last calibration date of specified board
age1439_clock_fs (on page 76)
−provides the module with the frequency of an external
sample clock
age1439_clock_fs_get (on page 76)
−gets the current external sample clock frequency
age1439_clock_recover (on page 77)
−allows recovery from an out-of-spec external sam-
ple clock
age1439_clock_setup (on page 78) −sets all timing parameters for commonly used mea-
surement setups
age1439_clock_setup_get (on page 78)
−gets the current clock setup
age1439_close (on page 86)
−closes the module's software connection
age1439_combo_setup (on page 87)
−a quick way to set blocksize, center frequency, and
signal bandwidth with one function
age1439_data_blocksize (on page 90)
−determines the size of the output data block
age1439_data_blocksize_get (on page 90)
−gets the output data block size
age1439_data_delay (on page 90)
−determines FIFO delay in continuous mode
age1439_data_delay_get (on page 90)
−gets FIFO delay in continuous mode
age1439_data_memsize_get (on page 88) −returns module's memory size in megabytes
age1439_data_mode (on page 90)
−selects block mode or continuous mode
age1439_data_mode_get (on page 90)
−gets the data mode
age1439_data_port (on page 90)
−selects VME bus, local bus or fiber interface for
output port transmission
age1439_data_port_get (on page 90)
−gets the output port designation
age1439_data_resolution (on page 90)
−selects 12 or 24 bits data resolution
age1439_data_resolution_get (on page 90) −gets the data resolution
age1439_data_scale_get (on page 89)
−gets data scale factor used to convert raw data to
volts
age1439_data_setup (on page 90)
−sets all format and data output flow parameters
age1439_data_spectral_order (on page 90)
−specifies the spectral order of the output
data.
age1439_data_spectral_order_get (on page 90)
−gets the spectral order of the output
data.
age1439_data_type (on page 90)
−selects real or complex output data
age1439_data_type_get (on page 90)
−gets output data type
age1439_data_xfersize (on page 96) −allows a specified amount of data to be read before
an entire block has been acquired
age1439_data_xfersize_get (on page 96)
−gets the data transfer size
age1439_driver_debug_level (on page 97)
−sets the debug level