Merrychef eikon e6 - Manual (Page 23)

E6 SERVICE MANUAL REV C 06/12
23
1
Cold Oven CLEANING INSTRUCTIONS e6
Complete COOL DOWN procedure and allow oven and
accessories to cool before commencing cleaning.
REMOVE & CLEAN Oven Parts:
1. Remove the air filters from the back of the oven.
2. Open the oven door, remove the cook plate, bottom jet
plate, and grease filters.
Wash all parts in warm soapy water. Wash off using a clean
cloth and plenty of clean, warm water.
Dry by using a fresh, clean cloth
.
CLEAN THE OVEN
1. Remove any spillages with disposable paper wipes.
Use a dry clean brush to remove any food particles from between the oven floor and the inside of the front door.
2. Wear protective rubber gloves and protective glasses, carefully spray a non-caustic proprietary branded Oven
Cleaner onto all the internal surfaces of the oven except the door seal (A).
3. For difficult areas, leave to soak for 10 minutes with the oven door open.
Use a non–abrasive nylon scrub pad/sponge to clean the cavity, roof and the inside of the door. Do not scrub the door
seal or use metallic scourers.
4. Wash off using a clean cloth and plenty of clean warm water and dry using a fresh clean cloth or paper towel.
Replace all the cleaned oven parts.
Close the oven door and wipe the outside of the oven with a damp cloth.
APPLY OVEN PROTECTOR:
1. Only apply to a clean oven. Spray proprietary branded
Oven Protector onto a sponge.
2. Spread Oven Protector lightly onto all internal surfaces
of the oven.
3. Spread Oven Protector lightly onto the internal surface of
the oven door avoiding the door seal.
Switch on the oven and preheat. When the oven has
reached operating temperature it will take about 30mins
to cure the Oven Protector.
Note: Oven protector turns light brown when cured.
2 2
3
WARNING:
DO NOT USE OVEN WITHOUT A CLEAN
AIR FILTER IN PLACE
WARNING:
DO NOT USE TOOLS
Cook Plate Jet Plate
(Under cook plate
& IR Element)
Grease
Filters
Air Filters