Merrychef eikon e6 - Manual (Page 7)

E6 SERVICE MANUAL REV C 06/12
7
1 3
8
9 10 11 12
MAIN FEATURES
1 ON/OFF SWITCH
ON (I) activates the oven, OFF (0) switches the oven to standby
mode. IT DOES NOT ISOLATE INTERNAL WIRING FROM THE
MAINS SUPPLY.
2 CONTROL PANEL
Touch sensitive controls (easyToUCH) for controlling oven
functions, including diagnostics and service mode.
3 USB menuKey
A socket, located under the logo, allows a USB menuKey to be
used to update the cooking programs and oven firmware on
the control board.
4 OVEN CAVITY
The oven cavity is mostly constructed from stainless steel
panels which must be kept clean to avoid contamination of
food products and allow the oven to perform at peak
efficiency.
5 JET PLATE
Direct air into the cavity. It must be cleaned on a regular basis,
and kept free of debris.
6 OVEN DOOR
The twin-skinned door has a thermally insulated inner section to
lower the surface temperature and incorporates a microwave
choke.
7 DOOR SEAL
Provides a tight seal around the door and must be kept clean.
The seal must be checked regularly and replaced if worn or
damaged.
8 AIR FILTERS
The air intake provides cooling air for internal components and
must be cleaned daily and must NOT be obstructed. The filters)
must be in place for the oven to function properly.
9 STEAM VENT
Vents steam from the oven cavity at the base. (Vents from left
side from rear view/ right side from front view)
10 SPEC PLATE
The spec plate, located on the rear oven cover, states the Model,
Serial Number, and Electrical Ratings.
11 MAINS ELECTRIC POWER CABLE
Located on the rear of the oven and must be replaced if worn or damaged.
2
3
4
5
6
7
1
11
8
9
10