Beijer Electronics SCOM RBC EN - Manual (Page 13)

Command Reference
Beijer Electronics, MAEN993 13
5 Command Reference
The Lauer SCOM protocol exposes many commands for remote control of a Beijer
Electronics RBC by a dedicated software. It supports all standard SCOM commands,
as well as the new Lauer command set for special purpose functions.
This chapter describes each SCOM command and sub-commands for the currently
available device, Beijer Electronics RBC.
Although each Beijer Electronics RBC is based on the same base firmware and uses
the same communication, some commands/sub-commands are hardware dependant
and not supported for each device of the series, due to the differences within the de-
vice hardware. These differences and required firmware versions are indicated in de-
tail for each command description.
Note:
Response messages may be generated and sent back, even if the commands/sub com-
mands are not supported within a particular firmware version or if they are invalid.