15 lau_config_setdisplayadr (0x018f), Lau_config_setdisplayadr (0x018f) – Beijer Electronics SCOM RBC EN User Manual
Page 40
Command Reference
40
Beijer Electronics, MAEN993
5.6.15 LAU_CONFIG_SETDISPLAYADR (0x018F)
Device Address
Stores a software address of a device in the internal memory. This address is used, if
the device is configured to override the DIL switch settings. Only the address is
changed; not the group.
Supported since Firmware Version
LAUER RBC: 0.0.0.1
Command Stream
Response Message (Acknowledge)
Response Message (Negative Acknowledge)
Under normal operation conditions, a device never sends a negative acknowledge in
response to this command.
Maximum Lr for this Command
9
Note:
The changes made by this command will become active only after a restart of the de-
vice. This avoids loosing the connection to the device during configuration.
0
1
2
3
4
5
6
7...9
10
0x07
ADR
0x4C
0x41
0x55
0x03
ICHKH 0x01
0x27
Param ICHKD
Param
Value:
0 ...15 (0x00 … 0x0F)
Type:
Byte
Length:
1
Description: Software device address
0
1
2
3
4
5
6
7
8
0x06
ADR
0x4C
0x41
0x55
0x01
ICHKH
Ret
ICHKD
Ret
Value:
0 ...15 (0x00 … 0x0F)
Type:
Byte
Length:
1
Description: Software configured device address