Beijer Electronics BFI-P2 V1.21 - Manual (Page 19)

User Guide Revision 1.121
www.beijerelectronics.com
19
4. Electrical Installation
4.1. Grounding the Drive
This manual is intended as a guide for proper installation. The manufacturer cannot assume responsibility for the compliance or
the non‐compliance to any code, national, local or otherwise, for the proper installation of this drive or associated equipment. A
hazard of personal injury and/or equipment damage exists if codes are ignored during installation.
This Drive contains high voltage capacitors that take time to discharge after removal of the main supply. Before working on the
drive, ensure isolation of the main supply from line inputs. Wait ten (10) minutes for the capacitors to discharge to safe voltage
levels. Failure to observe this precaution could result in severe bodily injury or loss of life.
Only qualified electrical personnel familiar with the construction and operation of this equipment and the hazards involved should
install, adjust, operate, or service this equipment. Read and understand this manual and other applicable manuals in their entirety
before proceeding. Failure to observe this precaution could result in severe bodily injury or loss of life.
4.1.1. Recommended installation for EMC compliance.