BrandTech Scientific Transferpette electronic - Manual (Page 53)

➞
1x
1x
1x
1x
English
Press the pipetting key once
to discharge the liquid. The
rhombus is shown in the dis-
play. The liquid is discharged
very slowly.
6.
Discharge liquid
in the GEL mode
Interrupt discharging
To interrupt discharging,
press the pipetting key
again. The display shows the
volume discharged prior to
interruption.
Press the ENTER key after
the last pipetting operation.
The display shows ‚blo‘ for
blow-out.
7.
Initiate blow-out
Press the pipetting key
once to initiate the blow-out
process. The residual liquid
is discharged.
After the residual liquid is
discharged (blow-out), the
display moves back to the
start position.
8.
End pipetting
Electrophoresis (GEL) Mode
What to do How to do it Keys to press Display readout
The GEL mode operates using a very slow discharge speed to prevent swirling of the samples. To assure
optimal discharging into a gel, this discharge speed is fixed for the GEL mode. This speed is significantly
slower than level 1 and cannot be selected individually.
Note:
53