Alcatel-Lucent 7750 SR OS - Manual (Page 368)

Page 368 7750 SR OS Router Configuration Guide
qtag1, qtag2 — Specifies the encapsulation value used to identify the SAP on the port or sub-port. If
this parameter is not specificially defined, the default value is 0.
Values qtag1: 0 — 4094
qtag2 : * | 0 — 4094
sdp-id — The SDP identifier.
Values 1 — 17407
vc-id — The virtual circuit identifier. This value is used to validate the VC ID portion of each mesh
SDP binding defined in the service. The default value of this object is equal to the service ID.
Values 1 — 4294967295
http-redirect url — Specifies the HTTP web address that will be sent to the user’s browser. Note
that http-redirect is not supported on 7750 SR-1 or 7450 ESS-1 models.
Values 255 characters maximum
action
Syntax action {drop | forward}
no action
Context config>filter>ipv6-filter>entry
Description This command specifies the action to take for packets that match this filter entry. The action keyword
must be entered and a keyword specified in order for the entry to be active.
Multiple action statements entered will overwrite previous actions parameters when defined.
The no form of the command removes the specified action statement. The filter entry is considered
incomplete and hence rendered inactive without the action keyword.
Default drop
Parameters [drop | forward] — Specifies the action to take on packets matching the entry criteria.
drop specifies packets matching the entry criteria will be dropped.
forward specifies packets matching the entry criteria will be forwarded.
filter-sample
Syntax [no] filter-sample
Context config>filter>ip-filter>entry
Description Specifies that traffic matching the associated IP filter entry is sampled if the IP interface is set to
cflowd acl.
If the cflowd is either not enabled or set to cflowd interface mode, this command is ignored.
The no form removes this command for the system configuration, disallowing the sampling of
packets if the ingress interface is in cflowd acl mode.