Alcatel-Lucent 7750 SR OS - Manual (Page 47)

IP Router Configuration
7750 SR OS Router Configuration Guide Page 47
managed-
configuration
Sets the managed address configuration flag. This flag indicates that
DHCPv6 is available for address configuration in addition to any address
autoconfigured using stateless address autoconfiguration. 116
max-advertisement-
interval
Configures the maximum interval between sending router advertisement
messages. 117
min-advertisement-
interval
Configures the minimum interval between sending ICMPv6 neighbor
discovery router advertisement messages. 117
mtu Configures the MTU for the nodes to use to send packets on the link. 117
other-stateful-
configuration
Sets the “Other configuration” flag. This flag indicates that DHCPv6lite is
available for autoconfiguration of other (non-address) information such as
DNS-related information or information on other servers in the network. 118
prefix Configures an IPv6 prefix in the router advertisement messages. 118
autonomous Specifies whether the prefix can be used for stateless address
autoconfiguration. 118
on-link Specifies whether the prefix can be used for onlink determination. 119
preferred-lifetime Configures the length of time that the prefix remains preferred. 119
valid-lifetime Configures the length of time that the prefix is valid. 119
reachable-time Configures how long this router should be considered reachable by other
nodes on the link after receiving a reachability confirmation. 119
retransmit-time Configures the retransmission frequency of neighbor solicitation
messages. 120
router-lifetime Sets the router lifetime. 120
no shutdown Enables router advertisement on an interface. 120
Configure interface ICMP
config>router>interface
icmp Configures ICMP parameters on a network IP interface. 109
mask-reply Enables responses to ICMP mask requests on the router interface. 109
redirects Enables and configures the rate for ICMP redirect messages issued on the
router interface. 109
ttl-expired Configures the rate that ICMP TTL expired messages are issued by the
interface. 110
unreachables Enables and configures the rate for ICMP host and network destination
unreachable messages issued on the router interface. 110
Table 4: CLI Commands to Configure Basic IP Router Parameters (Continued)
Command Description Page