WIKA CF2S - Manual (Page 10)

Operating Instructions Temperature Indicating Controller CF2S
V1.2 • 08/2004 - 10 -
The alarm action type and the pattern end output when program control can be
designated by the rotary switch A1 (SW302) and A2 (SW301).
The rotary switch A2 (SW301) is equipped only when the option A2 is applied.
Rotary switch A1 (SW302): Alarm 1 (A1) action or Pattern end 1 output.
Rotary switch A2 (SW301): Alarm 2 (A2) action or Pattern end 2 output.
Factory adjusted as No alarm action, [ ].
[Table 3.2-3]
Alarm 1 action
A1 Rotary Sw.
(Sw302) No.
Alarm 2 action
A2 Rotary Sw.
(Sw301) No.
No alarm action 0 No alarm action 0
High limit alarm 1 High limit alarm 1
Low limit alarm 2 Low limit alarm 2
High/Low limits alarm 3 High/Low limits alarm 3
Hi/Lo limit range alarm 4 Hi/Lo limit range alarm 4
Process high alarm 5 Process high alarm 5
Process low alarm 6 Process low alarm 6
Pattern end 1 output 7 Pattern end 2 output 7
3.3 Insertion of the internal assembly
When the setup is completed, insert the internal assembly into the case.
Firmly insert the assembly until it is locked by the hook at the bottom of the instrument.
(There will be a clicking sound.)
Caution
Do not confuse the top and bottom of the internal assembly.
If inserting the assembly into the case by force in the wrong direction, the PCB
may be damaged.