WIKA CF2S - Manual (Page 18)

Operating Instructions Temperature Indicating Controller CF2S
V1.2 • 08/2004 - 18 -
Main setting value Mode to set the high limit of main setting value.
high limit setting (If scaling high limit value is changed,
Setting value this setting value will be changed as well.)
Setting range: Main setting value low limit to scaling high limit value
[Factory adjusted as 400°C]
Main setting value Mode to set the low limit of main setting value.
low limit setting (If scaling low limit value is changed,
Setting value this setting value will be changed as well.)
Setting range: Scaling low limit value to main setting value high limit
[Factory adjusted as 0°C]
Sensor correction setting Mode to set the correct value of the sensor.
Setting value Setting range: –100.0 to 100.0°C
[Factory adjusted as 0.0°C]
Instrument number setting Mode to set the Instrument number individually
Setting value to each instrument when communicating by
connecting multiple instruments in serial communication.
Setting range: 0 to 95 [Factory adjusted as 0]
This display is available only when the option
[CR2] or [CR5] is applied.
Transfer rate selection Mode to select a communication transfer rate
Selection to meet the rate of the host computer.
[Factory adjusted as 9600bps]
2400bps
4800bps
9600bps
19200bps
This display is available only when the option [CR2] or [CR5] is applied.
Communication protocol Mode to select a communication protocol
selection between the CF2S and the host computer.
Selection [Factory adjusted as ]
WIKA standard protocol
Based on Modbus, ASCII mode
This display is available only when the option [CR2] or [CR5] is applied.
PV/SV display mode
Actual Main setting
Temperature value