Correction mode, Initial correction value, Alue – RADWAG WPW/T 60/HR3/FH Waterproof Control Scales User Manual
Page 109: Initial correction v
Advertising
24.8.6.1. Correction mode
Procedure:
• Enter
<P7 WORK MODES> and then:
NONE
-
Correction function disabled
CONSTAN
T
-
Dosing refered to a constant nominal value of
correction
AUTO
-
enabling automatic correction
Return to weighing:
See 11.3.
24.8.6.2. Initial correction value
In parameter <P7.4.6.2 START CORRECTION> a user can set a
mass value to be subtracted from or added to the nominal mass.
Procedure:
• Enter
<P7 WORK MODES> and then:
- 109 -
Advertising
This manual is related to the following products: