Configuration of work modes of analogue modules, Onfiguration of work modes of analogue modules – RADWAG WPW/T 60/HR3/FH Waterproof Control Scales User Manual
Page 123
Advertising
Mounting of AN module on the main board of PUE C41H
27.2.3. Configuration of work modes of analogue modules
A work mode of analogue modules can be set using S1 switch according
to the drawings above
(
table „configuration of analogue modules ”).
Near the S1 switch on the PCB you can find a description.
- 123 -
Advertising
This manual is related to the following products: