Pioneer DEH-P70BT - Manual (Page 79)

As you select segments of the clock display
the segment selected will blink.
3 Push Multi-Control up or down to set
the clock.
Pushing Multi-Control up will increase the
selected hour or minute. Pushing
Multi-Control down will decrease the se-
lected hour or minute.
Notes
! You can match the clock to a time signal by
pressing Multi-Control.
 If the minute is 0029, the minutes are
rounded down. (e.g., 10:18 becomes
10:00.)
 If the minute is 3059, the minutes are
rounded up. (e.g., 10:36 becomes 11:00.)
! Even when the sources are off, the clock dis-
play appears on the display.
Turning the off clock
display on or off
If the off clock display is turned on, when the
sources and the feature demo are off, the ca-
lendar and the clock display appears on the
display.
1 Use Multi-Control to select Off clock.
Off clock appears in the display.
2 Press Multi-Control to turn the off clock
display on.
Off clock ON appears in the display.
# To turn the off clock display off, press
Multi-Control again.
Setting the FM tuning step
Normally the FM tuning step employed by
seek tuning is 50 kHz. When AF or TA is on,
the tuning step automatically changes to 100
kHz. It may be preferable to set the tuning step
to 50 kHz when AF is on.
1 Use Multi-Control to select FM step.
FM step appears in the display.
2 Press Multi-Control to select the FM
tuning step.
Pressing Multi-Control repeatedly will switch
the FM tuning step between 50 kHz and 100
kHz while AF or TA is on. The selected FM tun-
ing step will appear in the display.
Note
The tuning step remains at 50 kHz during manual
tuning.
Switching Auto PI Seek
The unit can automatically search for a differ-
ent station with the same programming, even
during preset recall.
1 Use Multi-Control to select
Auto PI seek.
Auto PI seek appears in the display.
2 Press Multi-Control to turn Auto PI seek
on.
Auto PI ON appears in the display.
# To turn Auto PI seek off, press Multi-Control
again.
Initial Settings
En
79
English
Section
15