Brocade Communications Systems 415 - Manual (Page 117)

Brocade Adapters Administrator’s Guide 103
53-1001583-01
Protocol Tests dialog box
A
Protocol Tests dialog box
The Protocol Tests dialog box enables you to run diagnostic tests on Fibre Channel components.
Opening the dialog box
1. Select Configure > Diagnostics from the Host Connectivity Manager.
2. Click the FC Protocol Tests tab.
Fields and components
Using the dialog box
Refer to the following topics for specific procedures using this dialog box:
• “Configuring beaconing using HCM”
• “supportSave collection sources”
Field Description
Echo Test check box Check to run an Echo Test on the selected port.
FC Ping Test check box Check to run an FC Ping Test on the selected port.
FC Trace Route check box Check to run an FC Traceroute on the selected port.
Add button Click to add a selected port, logical port, or target to the test list.
Remove button Click to remove a selected port, logical port, or target from the test
list.
Remove All button Click to remove all ports, logical ports, and targets from the test list.
Test Cycle text box Specify the number of times the test runs. The default value is 100.
Test Log table Displays the time the test was run, type of test run, status of the test,
configuration, and the results.
Port list Select a port on which the test will be run from the list.
Target list Select a target on which the test will be run from the list.
Logical Port list Select a logical port on which the test will be run from the list.
Stop on Error check box Check to flag the system to stop running the test if an error occurs.
Start button Click to run the selected test.
Stop button Click to stop all pending tests.