Brocade Communications Systems 415 - Manual (Page 72)

58 Brocade Adapters Administrator’s Guide
53-1001583-01
Displaying test log details
5
4. Click the check box that corresponds to the protocol test you are running.
5. Select a port, target, and logical port from the lists, and click Add to add it to the test table.
6. Define how many times the test runs by specifying the test cycle number. The default test cycle
number is 1.
7. Click Start to run the test.
Displaying test log details
1. Select Configure > Diagnostics from the Host Connectivity Manager.
2. Run any diagnostic test.
3. Select and double-click a row of the test results in the bottom pane.
The Test Log Details dialog box, shown in Figure 23 , displays.
FIGURE 23 Test Log Details for Echo Test dialog box